The Tone Thread
Re: The Tone Thread
I liked the slide sound and yes, that's throb is very Univibey
Re: The Tone Thread
Thanks Bob...I gotta say, I'm pretty impressed with the Phase 95 mini...Not only is it cute as hell being so small (same mini size as the Tubescreamer I have btw...), it's a good sounding little pedal...It's actually 4 pedals in one, sorta, but again, I'm really liking it, a lot...
Thanks again dude...

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
Miner, what the difference between GTR1 and GTR2?
GTR2 sounds better and bigger to me!
GTR2 sounds better and bigger to me!
Re: The Tone Thread
There's no difference in any of the amp settings, mic placement or anything dude...Not sure why it sounds bigger/better, other than maybe I played it a little harder/better??? Same guitar & everything man...

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
That's really weird. The first one sounds a bit sterile like it was recorded at low volume and the 2nd one sounds much more lively and has more energy. Maybe cos you were playing along with the first one and more into it? I dunno.
I haven't heard them in a mix yet. I'll listen to that and then to these clips again in the morning when I get back to the office.
None of your tones are bad though miner.
Re: The Tone Thread
Thanks again Jdude...It's weird to me too, because I recorded those guitars back to back/one right after another, & didn't touch anything until I recorded the slide, then all I did was bump the gain from 2.5 up to 5 on the dial...JD01 wrote: ↑Mon Sep 16, 2019 4:26 pm That's really weird. The first one sounds a bit sterile like it was recorded at low volume and the 2nd one sounds much more lively and has more energy. Maybe cos you were playing along with the first one and more into it? I dunno.
I haven't heard them in a mix yet. I'll listen to that and then to these clips again in the morning when I get back to the office.
None of your tones are bad though miner.
They weren't recorded at low volume either...Well, maybe if you compare them to how loud Greg tracks his guitars at

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
Can you here the difference though?Minerman wrote: ↑Mon Sep 16, 2019 5:40 pmThanks again Jdude...It's weird to me too, because I recorded those guitars back to back/one right after another, & didn't touch anything until I recorded the slide, then all I did was bump the gain from 2.5 up to 5 on the dial...JD01 wrote: ↑Mon Sep 16, 2019 4:26 pm That's really weird. The first one sounds a bit sterile like it was recorded at low volume and the 2nd one sounds much more lively and has more energy. Maybe cos you were playing along with the first one and more into it? I dunno.
I haven't heard them in a mix yet. I'll listen to that and then to these clips again in the morning when I get back to the office.
None of your tones are bad though miner.
They weren't recorded at low volume either...Well, maybe if you compare them to how loud Greg tracks his guitars at, so again, I'm not sure what's up...
I don't record as loud as Greg either. That would be too much for my little room anyway, I record with it peaking at just over 100db.
Re: The Tone Thread
On the point, I think it's true that a room has a maximum volume that'll sound good.
Re: The Tone Thread
I can hear a difference between my tracks & Greg's tracks for sure....
I don't know how big the room is Greg uses, but my room here is about 12' x 10'...
Not terribly small, but I could use more space for sure, but it'll work, hell it has to...
I actually have no idea how many db's I usually record at, but I have thought about getting a proper decibel meter...I tried an app on a cell phone once, but it was terribly in-accurate...Maybe I need to invest in one...
You're probably right dude, it kinda makes sense...Again, my room isn't huge, but it's big enough to get good sounding tracks...I have pretty fair treatment again too...All the rockwool panels I'd made, I trashed 'em & used the rockwool for the 2nd ISO cab build, but I did buy some pre-made panels (Primacoustic) used from a local guy a few months ago...I need some basstraps, but the treatment I have has made a huge difference...
So I went from no treatment, to diy rockwool panels, back to no treatment, then to the Primacoustic panels...The treatment I have now doesn't deaden the room as much, but I had almost twice as much treatment in here too...I'll have to take some pics as I basically have a "new" room...I painted & re-did some things, plus the new panels, so it actually looks nothing like it did before...I even did some things to my closet in here (carpet on the walls, plus I built a little guitar rack for all my guitars), basically turning it into a vocal/acoustic instrument booth...Again, I'll have to snap some pics to show you guys...

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
Miner...
I like those Strat tones. So is that a Strat with a humbucker in the bridge I guess? Anyway, nice and chuggy. No low end problems. Midrange is nice and smooth.
I like those Strat tones. So is that a Strat with a humbucker in the bridge I guess? Anyway, nice and chuggy. No low end problems. Midrange is nice and smooth.
Re: The Tone Thread
Thanks Trip...Yep, strat with a humbucker (Mutt's "Hard Head Bridge")...It's just a cheap, 2009-ish MIM strat (I bought it new in 2009, so I'm assuming that's when it was built), but the p'ups transformed it into my favorite guitar...It's great IMO...

Thanks again dude...

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
I think it sounds pretty good minerdude. I think you're rushing the rhythm guitars a little bit on the initial chugs. Seems like the timing could be a hair tighter to me.Minerman wrote: ↑Sat Sep 14, 2019 9:36 pm Ok, here's a mix clip with the Phase 95 on the lead guitar...Probably not what you guys are used to, or expect, so I'll post the raw tracks later tonight....
Signal chain:
Strat bridge HB > Phase 95 (lead gtr only) > Chupacabra > attenuator > G12H > SM57
***Lead guitar only***Phase 95: 3 - 4 (speed) blue led (Phase 45 mode), script off
- Resonance...: 2
Presence.....: 6
Bass..........: 6
Middle........: 3
Treble........: 6
Master........: 8
Gain 2........: 2.5
Gain 1........: 2.7
ERA...........: modern
Bright 2.......: L
Bright 1.......: off
Focus..........:off
Same settings & mic placement for all the guitars except the lead part, I just turned Gain 2 up to "5"
Attenuator on "10" (this little thing attenuates a little, even when the volume is dimed, which it was for these tracks)...
There are effects on all the guitars (reverb on rhythm, reverb/chorus/delay/phase on lead), but again, I'll post the raw tracks later tonight...
Phase 95 MIX 9-14-2019.mp3
Lemme know what you guys think, not only the guitars, but the whole mix...
I like the slide but for me I think the warble is too fast on the phaser. I'd like it slowed down a little so it's more subtle.
Rebel Yell
Re: The Tone Thread
Just stopped for lunch, plugged my guitar in and started playing... quite liked the tone I had immediately and it was something that I very rarely play and don't think I've ever recorded before: A clean bridge humbucker.
So its my custom Doghouse Humbucker into my clean channel with everything on 5.
Just bashing away on some chords.
So its my custom Doghouse Humbucker into my clean channel with everything on 5.
Just bashing away on some chords.
Re: The Tone Thread
Sounds good. I like the tiny little bit of breakup in it.JD01 wrote: ↑Wed Sep 18, 2019 10:58 am Just stopped for lunch, plugged my guitar in and started playing... quite liked the tone I had immediately and it was something that I very rarely play and don't think I've ever recorded before: A clean bridge humbucker.
So its my custom Doghouse Humbucker into my clean channel with everything on 5.
Just bashing away on some chords.
CLean Humbucker.mp3
Rebel Yell
Re: The Tone Thread
Yeah - I normally play my split neck pickup clean and it stays pretty much totally clean and quite stratty.Greg_L wrote: ↑Wed Sep 18, 2019 11:09 amSounds good. I like the tiny little bit of breakup in it.JD01 wrote: ↑Wed Sep 18, 2019 10:58 am Just stopped for lunch, plugged my guitar in and started playing... quite liked the tone I had immediately and it was something that I very rarely play and don't think I've ever recorded before: A clean bridge humbucker.
So its my custom Doghouse Humbucker into my clean channel with everything on 5.
Just bashing away on some chords.
CLean Humbucker.mp3
I don't normally play clean that aggressively either, but I have a plan for Rec Challenge 3 which could use this tone on one side with my tele on the other. Mutt still has the guts of my tele though.
Re: The Tone Thread
Thanks Greg...Yeah, the timing is off, for sure, but no biggie...Greg_L wrote: ↑Wed Sep 18, 2019 8:36 am I think it sounds pretty good minerdude. I think you're rushing the rhythm guitars a little bit on the initial chugs. Seems like the timing could be a hair tighter to me.
I like the slide but for me I think the warble is too fast on the phaser. I'd like it slowed down a little so it's more subtle.
I'm really liking the Chupa/G12H combo, it's similar to a Greenback, just has a different character for lack of better explanation...Doesn't matter what speaker I use though, the Chupacabra is awesome to me...I absolutely love this amp & will never part with this one...
The way the phaser is set on that clip sounds more like a univibe to me...I'm impressed with this phaser pedal, a lot more than I thought I'd be...
Sounds pretty good Jdude...Just a bit of hair on it, which can be good for certain things...JD01 wrote: ↑Wed Sep 18, 2019 10:58 am Just stopped for lunch, plugged my guitar in and started playing... quite liked the tone I had immediately and it was something that I very rarely play and don't think I've ever recorded before: A clean bridge humbucker.
So its my custom Doghouse Humbucker into my clean channel with everything on 5.
Just bashing away on some chords.
CLean Humbucker.mp3
Ain't it great when you just plug in & it sounds good??? Glad you found your amp Jdude... Mutt's p'ups are the shizzle too...

Gibson, Fender, Ibanez, Jackson
Ceriatone, Marshall, EVH
TC Electronic, MXR, Yamaha
My music @ Reverbnation
Re: The Tone Thread
Cheers Miner. Yeah, one of them days. Just plugged in, strummed a G chord, liked it and kept going for a while.
Re: The Tone Thread
Working on an old song that me and a mate first recorded while I was doing my MSc. 2002 I think.
Anyway - here's the heavy tone... I reckon only Miner and Liv will actually like this but its come out pretty well for a heavy tone.
I've not really used the high gain channel on my amp much at all.
Anyway - here's the heavy tone... I reckon only Miner and Liv will actually like this but its come out pretty well for a heavy tone.
I've not really used the high gain channel on my amp much at all.
Re: The Tone Thread
That's pretty gross.JD01 wrote: ↑Wed Oct 02, 2019 6:14 am Working on an old song that me and a mate first recorded while I was doing my MSc. 2002 I think.
Anyway - here's the heavy tone... I reckon only Miner and Liv will actually like this but its come out pretty well for a heavy tone.
I've not really used the high gain channel on my amp much at all.
Heavy Tone 19.1.mp3
Rebel Yell
Re: The Tone Thread
I think it sounds pretty tidy for a heavy tone. I haven't added the bassline in yet.