Wiring Diagrams

[JD01]

Anyone know a site where I can get good wiring diagrams for a guitar?
Ideally I want to do "tele wiring" with a 4 way selector: Bridge/both in series/both in parallel/neck.

Although I was also considering trying to wire it with two volume pots and no tone pot so I can use the middle positions as a blend.

[paulman]

I'm certain I must have at least one good schematics site bookmarked, but as of yet I haven't found one in my mess of a bookmarks folder. I looked around a lot when I was figuring out how to wire my tele, and I bookmarked pretty much every source I used while building it. I'll let you know if I find the ones for wiring. If you need any resources for other aspects of the build, I do have a ton. They're even mostly organized, except for apparently wherever I got my wiring diagram from.

[JD01]

Cheers,

[muttley]

Anyone know a site where I can get good wiring diagrams for a guitar?
Ideally I want to do "tele wiring" with a 4 way selector: Bridge/both in series/both in parallel/neck.

Although I was also considering trying to wire it with two volume pots and no tone pot so I can use the middle positions as a blend.

You need to isolate the pickup cover from ground to do it. That isn't as simple as it sounds.

[muttley]

https://www.premierguitar.com/diy/mod-g ... ies-wiring

[muttley]

Thinking about it. You said you were looking at a strat neck pickup so it should be doable for you. Let me look at it tomorrow for you.

[Greg_L]

https://guitarelectronics.com/guitar-wiring-resources/

The ultimate resource. Damn near every configuration there is.

[JD01]

https://guitarelectronics.com/guitar-wiring-resources/

The ultimate resource. Damn near every configuration there is.

Cheers Greg. Think this is the basic version of what I'm after
https://guitarelectronics.com/tele-w-4-way-mod-switch/
If I want to go for two volumes I might have to look a bit harder.